Name:2 layers PCB with half holes plated
Board thickness:0.8MM
Copper thickness:1OZ
Minimum line width/space:6/6 mil
Minimum drilled hole diameter:0.35MM
Surface finish:ENIG
Special process:impedance control , half holes plated
Inquiry

Product Description

2 layers PCB with half holes plated           


Plated half-holes or castellated holes are plated half holes with half on the edges of the board. They are commonly used for breakout boards or small modules. You may have seen them on some Wi-Fi modules which are then soldered onto a larger PCB similar to the way in which ICs are mounted. Castellated holes are not available for single layer boards. 


How are they manufactured?


Firstly, whole plated through holes are made as usual on the edge of the boards. A milling tool is then used to cut the holes, along with the copper, in half. Since copper is much harder to mill and will likely cause the bit to break, heavy duty milling bits are used at a higher speed. This results in a smoother finish. Each half hole is then inspected in a dedicated station and deburred if necessary.


Hits: 【Print】 
Pre:2 layers PCB with red soldermask     Next:8 layers OSP PCB